System Board - HP 10 G2 2301 Maintenance And Service Manual

System board

Description
System board equipped with MTK 8127 Quad core 1.3 GHz,, 1 GB RAM memory, and 16 GB eMMC hard
drive
Before removing the system board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off, turn the tablet on, and then shut it down
through the operating system.
2. Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the battery (see
5. Remove the speaker (see
6. Remove the rear-facing webcamera (see
7. Remove the antenna board (see
8. Remove the touch screen board (see
9. Remove the power/volume button board (see
Remove the system board:
1. Remove the three Phillips screws (1) that secure the system board to the display panel assembly.
2. Carefully remove the system board (2), which is held with tape.
Reverse this procedure to install the system board.
Battery on page 13).
Speaker on page 14).
Rear-facing webcamera on page
Antenna board on page
Touch screen board and display cable on page
Power/volume button board on page
14).
16).
Spare part number
829931-001
17).
18).
System board 19