Auto Code Search - GE 11695 Instruction Manual

Programming Your Remote, cont.

Auto Code Search

The Auto Code Search, searches automatically
through all of the codes stored in this remote. Read
all the steps prior to starting the auto code search
tv cbl
as you will need to be prepared to lock-in the proper
input
code when found.
aux
tv cbl
menu
A B
setup
menu
D
A B
tv cbl
menu
list
A
tv cbl
exit
list
menu
A
list
list
input
dvd aux
input
1. Manually turn on the device you wish
to control.
dvd aux
setup
2. Press and hold the SETUP button
until the red indicator light stays on
C
(approximately 2 seconds) and then
release the button.
setup
3. Press and release the device button
C
on the remote (TV, CBL, DVD, AUX) the
dvd
type of device you wish to control. The
red indicator will blink once and then
remain on.
4. Point the remote at the device and
press and release the POWER button
(for TV) or PLAY button (for DVD, VCR,
B C
etc.) to start the search. The red
dvd
indicator will flash (approximately
every 2 seconds) as the remote
searches. Note: The remote must be
pointed at the device for the duration of
this search.
5. Place your finger on the #1 button so
B C
you are prepared to lock-in the code.
6. When the device shuts off or begins
playing, press the #1 button to lock-in
the code. The red indicator light will
turn off. Note: You have approximately
two seconds after the device shuts off
or begins playing to lock-in the code.
7. Point the remote at the device and
check to see if the remote operates the
device as desired. If it does, no further
programming is required for that
device. If it does not, return to step 2
and start the auto code
search again.
D
input
D
aux
setup
exit
input
D
aux
exit
setup
D
exit
exit
8