Panasonic EY7442 Service Manual page 12

Ref. No. 2H-1 Procedure 2A → 2B → 2C → 2D → 2E → 2F→
2G → 2H
Assembly of Adjusting screw and Clutch handle.
for EY7442 and EY7450
1. Hold the driving block with the click spring on top, and align the
smallest projection of adjusting screw with 45° right side of the clutch
case.
NOTE:
Make sure that the adjusting screw has its own correct direction
for proper assembly. Failure to do so, the clutch handle does not
rotate properly.
2. Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
3. Set the clutch handle with position 1 on top.
(Align the position 1 of clutch handle with the narrowest projection of
driving block.)
4. Insert the clutch handle with adjusting the tabs of adjusting screw
to the groove of inside clutch handle.
12