Removing/Reattaching Lower Control Panel Unit - Sony MSW-A2000 Installation Manual

1-12. Removing/Reattaching Lower
Control Panel Unit
The lower control panel unit is detachable from the main
unit, therefore operation with placing the single panel unit
on the table as a keyboard of a personal computer is
possible. (The length of the connected cable is about 62
centimeters.)
Front switch panel
Cable
Lower control panel unit
Not only connecting the cable to a CONTROL PANEL
connector in the front switch panel, but connection be-
tween the cable and a CONTROL PANEL connector in the
rear connector panel provides operating the lower control
panel. After connection, set a PANEL SELECT switch on
the switch panel as follows:
Connector to be connected
to lower control panel unit
Front (on the switch panel)
Rear (on the connector panel)
Settings when connecting the two lower control
units
When connecting the two lower control units to one MSW-
A2000/A2000P, select which operation to enable by
setting from the setup extended menu ITEM-117.
Operation Setting of ITEM-117
enabled
Front-side panel EXT or PARA
Rear-side panel EXT
Both panels PARA
n
ITEM-117's factory setting : EXT
MSW-A2000
MSW-A2000P
PANEL SELECT switch
Setting of PANEL
SELECT switch
FRONT side
REAR side
Setting of PANEL
SELECT switch
FRONT side
REAR side
REAR side

1-12. Removing/Reattaching Lower Control Panel Unit

Removal/Extension of the Lower Control Panel
Unit
1. After pressing the release levers, open the lower
control panel as shown in the figure below.
2. Disconnect the cable from the connector on the back
side of the lower control panel unit and from the cord
holder.
3. Remove the two screws shown in the figure.
Release lever
BVTT3 x 6
Lower control panel unit
Back view
Cable
Cable holder
Connector
4. Lightly draw the lower control panel unit toward you,
and then lift it upward.
Lower control panel unit
Release lever
BVTT3 x 6
1-19