Maintenance And Storage; Optional Items - Panasonic EW6011 Operating Instructions Manual

STORAGE
Check that the power/strength dial is at the "O"
1
position.
2 Attach the pads to the pad storage plate.
• Untwist the cords before attaching the pads.
Failure to do so may prevent the cord from being taken up all the
way.
3 Take up the cord.
• Slide the cord take-up switch on the side of the main unit in the
direction of the arrow.
• Take up the cord while making sure the cord is not twisted.
If the cord is taken up while twisted, this may prevent the cord
from being taken up all the way.
• If the cord take-up stops midway, pull out the cord a little and
again take up the cord.
The cord take-up has been designed to operate at a safe speed to
prevent injury.
4 Store the pad storage plate into the storage case.
• Place the pad storage plate (attached with pads) into the storage
case.
Place the main unit on top of the storage case.
5
• Be sure the cord is not sandwiched between the main unit and the
case.
- Doing so may damage the cord.
WARNING!
• Do not wrap the cord while the pads are attached to your skin.
• Wrap the cord after attaching the pads to the pad storage plate.
- Failure to do so may result in injury.
GB14

MAINTENANCE AND STORAGE

* First check that the power is off.
Wipe the main unit with a cloth lightly dampened with
lukewarm water.
• Never use thinner, benzine or alcohol.
Doing so may result in malfunction or cracking or
discoloration of parts.
• Do not disassemble the main unit, drop it from a high
position, or apply an unreasonable force on the main unit.
• Do not place the device in locations having a high temperature or humidity or in direct sunlight.
• Remove the batteries if the device is not to be used for a prolonged period of time.
CAUTION!
• Store the device in a place that is out of reach of children.
- Failure to do so may result in an accident or trouble.
IF THE PADS LOSE THEIR ADHESIVENESS
The pads can be used approximately 400 times (with washing in cold water).
If the pads become dirty and lose their adhesiveness (usually after 15-20 times), they can be
washed in water to restore their adhesiveness. The pads can be washed in this way about 20
times. (The useful life of the pads may be shortened by factors such as how often they are washed,
how they are stored, and skin condition.)
1 Remove the conductive pad plugs from the pads.
• The conductive pad plug connectors may rust if they become wet.
2 Use your fingertips to gently wash the adhesive surface of the pad
with a small amount of running water for about 10 seconds or less.
• Do not rub the adhesive surface with your fingernails or a brush.
• Do not use detergents.
• Do not knead or soak the pads.
Shake off any water, place the pads with their adhesive
3
surfaces facing up, let the surfaces air-dry, and then attach
the pads to the pad storage plate.
• After washing the pads, do not wipe the adhesive surfaces with a tissue
paper or cloth. Doing so may result in the tissue paper or cloth sticking to the
adhesive surfaces. If they become stuck to the adhesive surfaces by accident, do not forcibly
peel them off but wet the surfaces and they will easily come off.
• The pads are consumable items. If the adhesive surfaces become worn or damaged,
purchase new pads.

OPTIONAL ITEMS

Replacement pads (two)
EW0603
Back side
(adhesive
surface)
GB15