D-Link DVG-5004S User Manual page 77

DVG-5004S User's Manual
Save Settings
When all setting procedures are completed, dial 509 (Save Settings) from phone keypad. Wait for about
three seconds, you should hear a voice prompt "1 (one)." You can now hang up the phone and please
reboot the VoIP Gateway to enable the new settings.
To inquire about the current VoIP Gateway WAN Port IP address setting
After completing all your settings, dial 101 from the keypad, then you can hear the system play back the
current WAN Port IP address. If the system does not play back the IP address after dialing 101, this
indicates that the VoIP Gateway currently is not connected to the Internet. Please check and make sure the
cable connections, account numbers, and passwords are correct.
4-1-1 IVR Functions Table:
Function Description
Code
111/101 WAN Port IP address Set/Query
112/102 WAN Port Subnet Mask Set/Query
113/103 WAN Port Default Gateway Set/Query
114/104 Current Network IP Access Set/Query (1: Static IP, 2: DHCP, 3: PPPoE)
115/105 DNS IP address Set/Query
118 Restart
311/301 LAN Port IP Set/Query
312/302 LAN Port Subnet Mask Set/Query
109 Restore factory default IP address configuration
409 Restore factory default settings
509 Save settings
D-Link Systems, Inc.
VoIP Gateway Configuration
Example / Notes
Dial function code 114 and then dial
1 for a Static IP connection then
setup the IP address.
A static IP address for WAN Port
IP：192.168.1.2
Mask：255.255.255.0
Gateway：192.168.1.254
77