Connecting External Equipment To The Av Output - Silvercrest LT910 User Manual And Service Information

Connecting External Equipment to the AV Output

You can transfer the picture and sound of your SilverCrest LT 910 to an external
device (e.g. a TV set). In this case, the picture and sound will not be played via
the screen and speaker of your LT 910 but played on those of the external device.
How to connect external AV equipment to your LT 910:
1. Make sure that the AV equipment has a common analogue AV input.
Normally, it can be identified by three coloured receptacles (yellow, red and
white) on the device. Please also read the User's Manual of your external AV
equipment (for instance of your TV set) to find out where the AV inputs are
located.
2. Connect the supplied AV cable to the AV output (13) of your SilverCrest LT
910 and to your external TV set. Always pay attention to the colour codes.
Connect the yellow plug to the yellow receptacle (for the video signal) and the
red and white plugs to the red and white receptacles (for the audio signal).
3. It is possible that you may have to switch your AV equipment to the correct AV
signal source in order for the picture and sound to be visible and audible.
Please also read the User's Manual of your external AV equipment (for
instance of your TV set) to find out how to watch and listen to the signal
transferred to the AV inputs.
As soon as you connect the small plug of the supplied AV cable to
the receptacle (13) of your SilverCrest LT 910, the screen will turn
off and the sound is muted.
SilverCrest LT 910
55 - English