Measurements And Adjustments; Necessary Instruments; Set To The Unit To Adjustment Mode; Caution On Optical Pickup - Panasonic SJ-MD150 Servise Manual

I/O
Pin Terminal
No. Name
95 P102/AN2 - Not used, connected to GND
96 P101/AN1 - Not used, connected to GND
97 - GND terminal
AV
SS
98 P100/AN0 - Not used, connected to GND
99 VREF I Reference voltage input
I Power supply terminal
100 AV
CC

17. Measurements and Adjustments

Note:
Because this unit uses the optical magnetic recording, the unit outputs over 10 times more laser than a CD player
does. In adjustment mode, the laser is always being output. Therefore, be especially careful not to look laser
beam directly or to touch the laser beam when adjusting the unit and checking its operation.

17.1. Necessary instruments

- Laser power meter (LE8010)
- Test disc (Pre-mastered disc RFKV0006 or RFKV0014)
- Recordable disc available on sales route / (with music recorded)
- Insulated driver for adjustment such as a ceramic driver
- Extension cable kit (RFKZJMD100EK)
- Remote control transmitter

17.2. Set to the unit to adjustment mode

1. Turn the power ON.
2. With no MD loaded in the unit, press and hold the STOP button (
pressing the STOP button (
seconds. The unit is set to the self-diagnostic function and is displayed "MD TEST". Refer to

Caution on optical pickup:

- The optical pickup and the magnetic head are structured precisely; therefore, they are very fragile. Be careful not to touch
them with the edge of laser power meter.
- The sensor of the laser power meter is a very fine part. Be careful not to touch it to the optical pickup lens.
- The focus point of the laser reaches to 180°C. Therefore, avoid using laser power for a long time because the sensor of
the laser power meter may be burned.
Function
), press the F.SEARCH button (
Fig. 17-1.
41
) for at least 2 seconds. And then while still
Fig. 17-1.
) for at least 2