Programming The Control Panel; Enabling The D1260/D1260B Keypad; Figure 11: Enhanced Command Center Prompt In; Rps - Bosch D1260 Installation Manual

D1260/D1260B | Installation Guide | 4.0
4.0 Programming the Control
Panel
The D1260/D1260B Keypad is compatible with Bosch
Control Panels with versions 6.40 or higher. To
program the D1260/D1260B, version 1.15 or higher of
the 9000MAIN handler or version 3.60 or higher of
remote programming software (RPS) is required.
4.1

Enabling the D1260/D1260B Keypad

1. Double-click on the RPS icon.
2. Enter a valid username and password.
3. Double-click on the desired control panel.
4. Under "D9412 Program Record Sheet" locate the
section called "COMMAND CENTER
(9000MAIN)".
5. In the lower pane, locate Enhanced Command
Center (Figure 11).

Figure 11: Enhanced Command Center Prompt in

RPS

6. Change Enhanced Command Center for the
keypad address to Yes.
When toggling the parameter from No to
Yes, reset the control panel to ensure it
takes effect.
12

Programming the Control Panel

Figure 11 assumes the keypad is CC Address 1.
For more information, refer to the control panel's
program entry guide.
7. The Display Revision (Command 59) function
(under USER INTERFACE (9000MAIN)
Command Center Functions) must be enabled (E)
in the control panel's programming for the
D1260/D1260B to work (Figure 12).
Figure 12: Enable Display Revision Prompt in
8. After completing a RPS programming session, but
before exiting RPS, reset the control panel by
clicking the Reset control panel checkbox before
clicking OK).
9. If the control panel is not reset, the keypad shows
Incorrect Panel program
settings..."Enhanced CMD CTR" should
be set to YES.
RPS
Bosch Security Systems | 9/04 | 48101E