Sony DCR-PC330 Service Manual page 38

DCR-PC330/PC330E
STROBOSCOPE SECTION
ST insulating sheet
FP-707 board
LENS SECTION
Tape (A)
LED
FP-706 board
Laser unit
HELP
Flexible
board
Condenser insulating sheet
Light guide
cover
Vibration proof tape
FP-706 board
Three solderings
Adjust the flexible
board so that it
comes to this
width of the cap.
FK flexible fixed sheet
CD shield sheet (A)
Caution
When soldering the laser unit on the FP-706 board,
observe the following things.
(Refer to Service Note (page 1-3)).
Observe the following conditions of temperature
and time of soldering.
Temperature of soldering iron : 350 °
Time of contacting the soldering : 3 seconds
iron with the solder
The laser diode may suffer electrostatic breakdown
because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the
human body.
During repair, pay attention to electrostatic breakdown
and also use the procedure in the printed matter which
is included in the repair parts.
The flexible board is easily damaged and should be
handled with care.
Condenser insulating sheet
Elect 80MF cap
CDF sheet
CD-452 board
Vibration proof cushion