Removal Of Deflection Yoke - Toshiba MV9DM2 Service Manual

4. Insert one end of the Anode Support into the anode button,
then the other as shown in Fig. 3-5.
CRT
5. Confirm that the Support is securely connected.
6. Put on the Rubber Cap without moving any parts.

4. REMOVAL OF DEFLECTION YOKE

(Refer to Fig. 4-1)
Loosen the screw 1.
1.
2. Remove the Convergence • Purity Magnet in the
direction of arrow.
3. Remove the 3 Wedges.
4. Remove the Deflection Yoke in the direction of arrow.
INSTALLATION
Install new Deflection Yoke in reverse steps of REMOVAL.
NOTE
After adjusting the purity and the convergence, fix the
screw 1 and lock the wedges.
Wedge
Wedge
DISASSEMBLY INSTRUCTIONS
Support
1
(A)
Convergence •
Purity Magnet
Deflection Yoke
Fig. 3-5
Fig. 4-1
B3-2