Quick Start - NEC 175VXM User Manual

To unfold stand, follow these instructions:
. Place monitor face down on a non-abrasive surface (Figure 1).
2. Pull the stand holding the monitor with the other hand until the stand clicks
(Figure 2).
NOTE: Handle with care when pulling the stand.
NOTE: Reverse process to re-pack monitor.
Figure 
To attach the MultiSync LCD monitor to your system, follow these instructions:
. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (not
included) to the connector of the display card in your system (Figure A.1). Tighten
all screws.
For the PC with Analog output: Connect the 5-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure A.2). Tighten all screws.
For the MAC: Connect the MultiSync Macintosh cable adapter (not included) to
the computer, then attach the 5-pin mini D-SUB signal cable to the MultiSync
Macintosh cable adapter (Figure A.3). Tighten all screws.
NOTE: To obtain the MultiSync Macintosh cable adapter, call
NEC Display Solutions of America, Inc. at (800) 632-4662.
Figure A.
DVI Signal Cable
(not included)
Figure A.2
Macintosh Cable Adapter (not included)
Note: Some Macintosh systems do not
3

Quick Start

Figure 2
Figure A.3
require a Macintosh Cable Adapter