Connecting The Video Input; Connecting The Loop-Through Video; Connecting The Monitor; Connecting A Vga Monitor - Siemens SISTORE AX8 1000/200 V4.0 Installation Manual

6.1

Connecting the video input

6.2

Connecting the loop-through video

6.3

Connecting the monitor

6.4

Connecting a VGA monitor

Siemens AG
NOTE
z
Your DVR can be used with either PAL or NTSC equipment.
z
You cannot mix PAL and NTSC equipment. For example you cannot use a PAL camera and an
NTSC monitor.
Fig. 3 Video input connectors
Connect the coaxial cables from the video sources to the BNC Video In
connectors.
Fig. 4 Video loop-through connectors
If you would like to connect your video source to another device, you can use the
Loop BNC connectors.
NOTE
The Loop BNC connectors are auto terminated. Do not connect a cable to the Loop BNC unless it is
connected to a terminated device because it will cause poor quality video.
Fig. 5 Video Out connectors
Connect the main monitor to the Video Out connector.
Connect the spot monitor to the SPOT connector as needed.
Fig. 6 VGA connector
Installation
11
EN
05.2010