Quick Start - NEC MultiSync M700 User Manual

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the MultiSync M
combined signal cable to the connector of the display card in your system
(Figure A.1). Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included) to the
monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini
D-SUB end of the captive combined signal cable to the Macintosh cable
adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync M
NEC Technologies at (800) 820-1230.
15500291.wpc
M monitor to your system, follow
® ™
700
Figure A.1
cable adapter, call
700
Computer
Figure B.1
5
15-pin mini D-SUB of the captive
700
Captive Combined
Signal Cable
Mac Adapter
(Not included)
3
7/27/99, 3:41 PM
Captive Combined
Signal Cable
15-pin mini D-SUB
15-pin mini D-SUB