Safety Precautions And Maintenance - NEC AccuSync PV32 User Manual

Safety Precautions
and Maintenance
FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE
FOLLOWING WHEN SETTING UP AND USING THE
MONITOR:
• DO NOT OPEN THE MONITOR. There are no user-servicable
parts inside and opening or removing covers may expose you to
dangerous shock hazards or other risks. Refer all servicing to
qualified service personnel.
• Do not spill any liquids into the cabinet or use your monitor near
water.
• Do not insert objects of any kind into the cabinet slots, as they
may touch dangerous voltage points, which can be harmful or
fatal or may cause electric shock, fire or equipment failure.
• Do not place any heavy objects on the power cord.
Damage to the cord may cause shock or fire.
• Do not place this product on a sloping or unstable cart, stand or
table, as the monitor may fall, causing serious damage to the
monitor.
• When operating the monitor with its AC 125-240V power supply,
use a power supply cord that matches the power supply voltage of
the AC power outlet being used. The power supply cord you use
must have been approved by and comply with the safety
standards of your country. (Type H05VV-F 3G 1mm
used in Europe)
• Do not place any objects onto the monitor and do not use the
monitor outdoors.
• The lamps in this product contain mercury.
Please dispose according to state, local, or federal law.
• Do not bend, crimp or otherwise damage the power cord.
• Do not use monitor in high temperature, humid, dusty, or oily
areas.
• Do not cover vent on monitor.
• If monitor or glass is broken, do not come in contact with the
liquid crystal.
• Handle broken glass with care.
• Allow adequate ventilation around the monitor so that heat can
properly dissipate. Do not block ventilated openings or place the
monitor near a radiator or other heat sources. Do not put anything
on top of monitor.
• The power cable connector is the primary means of detaching the
system from the power supply. The monitor should be installed
close to a power outlet that is easily accessible.
• Handle with care when transporting. Save packaging for
transporting.
• Keep the vent holes on the back of the product clean of dirt and
dust. It is recommended to wipe vent holes with a soft cloth a
minimum of once per month.

Safety Precautions and Maintenance

2 should be
English-3
CAUTION
Immediately unplug your monitor from the wall outlet and refer
servicing to qualified service personnel under the following
conditions:
• When the power supply cord or plug is damaged.
• If liquid has been spilled on, or objects have fallen into the
monitor.
• If the monitor has been exposed to rain or water.
• If the monitor has been dropped or the cabinet damaged.
• If the monitor does not operate normally by following operating
instructions.