Troubleshooting - NEC NDV-27 Owner's Manual

Troubleshooting

Symptom
No power. • The power cord is disconnected.
• No disc is inserted.
The power is on, but the
DVD player does not
work.
• The TV is not set to receive DVD signal
No picture.
output.
• The video cable is not connected
securely.
No sound. • The equipment connected with the audio
cable is not set to receive DVD signal
output.
• The power of the equipment connected with
the audio cable is turned off.
• The AUDIO options are set to the wrong
position.
• An unplayable disc is inserted.
The DVD player does not
start playback.
• The rating level is set.
• The remote control is not pointed at the
The remote control does
remote sensor on the DVD player.
not work properly.
• The remote control is too far from the
DVD player.
Possible Cause
• Plug the power cord into the wall outlet
securely.
• Insert a disc. (Check that the DVD or
audio CD indicator in the display
window is lit.)
• Select the appropriate video input mode on
the TV.
• Connect the video cable securely.
• Select the correct input mode of the audio
receiver so you can listen to the sound
from the DVD player.
• Turn on the equipment connected with the
audio cable.
• Set the Digital Audio Output to the
correct position, then turn on the DVD
player again by pressing POWER.
• Insert a playable disc. (Check the disc
type, color system, and regional code.)
• Cancel the rating function or change the
rating level.
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control closer to the
DVD player.
24
Correction