Unpacking And Assembly; Installation - Whirlpool 8LIECH-SCSSFP5W User Manual

UNPACKING AND ASSEMBLY

Remove the dispenser from packaging:
TO OPEN:
TOP
1. Lay the box containing the unit on its side.
2. Open bottom flaps of the cardboard box.
3. Stand cooler upright, with box flaps unfolded.
4. Pull box straight up.
5. Unpack the drip tray and insert it into the dispenser.
6. Keep original packing for the duration of warranty.

INSTALLATION

WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
Note: Do NOT plug in the power cord until told to do so.
1. Place the dispenser on a hard and level surface in a cool,
shaded location near a grounded wall outlet.
2. Position dispenser so that the back is at least 4 inches from
the wall, and there are at least 4 inches of clearance on
both sides.
3. To minimise vibrations and noise, use mat provided. If
required, place shims under the bottom of dispenser to
make it sit even without rocking.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
TOP
TOP
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
Model # 8LIECH-SCSSFP5W: Page 6
WARNING
Excessive Weight Hazard