Mounting On Ceiling - NEC PlasmaSync 42XP10 User Manual

Installation

Mounting on Ceiling

• Ensure that the ceiling is sturdy enough to support the
weight of the unit and the mounting apparatus over
time, against earthquakes, unexpected vibrations, and
other external forces.
• Be sure the unit is mounted to a solid structure within
the ceiling, such as a support beam. Secure the monitor
using bolts, spring lock washers, washer and nut.
• DO NOT mount to areas that have no supporting
internal structure. DO NOT use wood screws or anchor
screws for mounting. DO NOT mount the unit to trim
or to hanging fi xtures.
Maintenance
• Periodically check for loose screws, gaps, distortions,
or other problems that may occur with the mounting
apparatus. If a problem is detected, please refer to
qualifi ed personnel for service.
• Regularly check the mounting location for signs of
damage or weakness that may occur over time.
Please note the following when
mounting on wall or ceiling.
• When using mounting accessories other than those that
are NEC approved, they must comply with the VESA-
compatible (FDMlv1) mounting method.
• NEC strongly recommends
using size M8 screws
(16mm + thickness of
bracket in length). If using
screws longer than 16mm,
check the depth of the
hole.(Recommended Fasten
Force: 1125 - 1375N•cm)
NEC recommends
mounting interfaces that
comply with UL1678
standard in North America.
Orientation
When using the display in the portrait position, the monitor
should be rotated clockwise so that the left side is moved to
the top and the LED indicator light is on the bottom. Th is
will allow for proper ventilation and will extend the lifetime
of the monitor. Improper ventilation may shorten the
lifetime of the monitor.
When using the display in the portrait position, please turn
the Cooling Fan "ON" in the OPTION2 OSD menu.
- continued
Unit
16mm
Screw length should equal
depth of hole (16mm) + the
thickness of mounting bracket.
Cable Management
To conveniently manage cables, use the cable clamps
provided to bundle the power cord together with the signal
and audio cables at the back of the display.
To attach cable clamps:
1. Attach the cable clamps to the display. Insert the anchor of
the clamp into the hole on the back of the display. Th ere are 4
cable clamps and 4 clamp holes on the unit.
2. Aft er the cable clamp is positioned on the display, wrap the
end around the cables. Place the end of the clamp into the
Mounting
Bracket
slot near the anchor. Pull until cables are snug.
Clamps are designed to stay in place. Once in position, they
will be diffi cult to remove.
Screw
3. Cables can be routed to the right or left of the clamp. Use
the beaded bands to secure the cables together along their
Thickness
of Bracket
length. Make sure the cables are fully supported.
To detach clamps:
Using pliers, twist the clamp 90 degrees and pull outward.
It is possible that the clamp can weaken over time and
removing it may cause damage to the clamp.
Anchor
Closed Clamp
English-7
EXIT INPUT
Slot
Holes for Clamp
anchors
MUTE