Remove Monitor Stand For Mounting; Removing The Base - NEC AccuSync LCD22WMGX User Manual

Remove Monitor Stand for Mounting

To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (Figure R.1).
3. Remove the 3 screws connecting the monitor to the stand and remove the stand as indicated (Figure R.1).
The monitor is now ready for mounting in an alternative manner.
4. Connect the AC cord to the back of the monitor (Figure R.2).
5. Reverse this process to re-attach stand.
NOTE: Use only VESA-compatible alternative mounting method.
NOTE: Handle with care when removing monitor stand.
LCD22WMGX
Non-abrasive surface

Removing the Base

NOTE: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-abrasive surface (Figure R.1).
2. While using your thumbs, press the bottom tabs upward to unlock.
3. Pull the unlocked base off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use the screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be
mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor shall only be used with an approved arm (e.g. GS mark).
Specifications
4-SCREWS (M4)
(MAX depth: 10 mm)
Weight of LCD assembly: 5.0 kg (MAX) - LCD22WMGX
LCD24WMCX
Figure R.1
12 mm
7.0 kg (MAX) - LCD24WMCX
English-7
Tab
4 x 12 mm with lock washer and flat washer
M4
100 mm
100 mm
Figure R.2
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Tighten all screws