Sony VPH-G70Q Installation Manual page 106

Saving the Adjustment Data
Preset data at the factory
Memory architecture
106
(EN) Adjustments
Standard registration data and the input memory
If the adjusted registration data is saved as the standard data after installing
the projector, the registration data for all of the input memories will be
changed to reflect the new data in that installation condition. Therefore,
you can easily adjust the registration for each input signal.
For the procedure of how to save the standard data, see page 95 (EN).
The projector presets ten types of basic data in memory numbers 00 to 09
of the factory data and service data blocks.
Memory number Horizontal
frequency (fH)
00 15.7 kHz
01 24.8 kHz
02 31.5 kHz
03 48.3 kHz
04 64.0 kHz
05 75.0 kHz
06 93.7 kHz
07 106.3 kHz
08 31.5 kHz
09 33.8 kHz
The following adjustment data will be saved in three memory blocks.
Memory Adjustment data
Input memory
Picture control (CONTRAST,
BRIGHT, COLOR, HUE,
SHARP)
SIZE/SHIFT
Blanking
Color temperature
Clamp position
V SHIFT
Registration
Magnetic focus, AQP/DQP
Color temperature
White balance
memory
(BIAS/GAIN data for
each color temperature
of each screen)
Setting memory
Baud rate, CRT timer,
STATUS ON/OFF, language,
index, brightness/color
uniformity, video memory
Vertical
Type of the
frequency (fV)
input signal
60 Hz Video (NTSC
56 Hz RGB
60 Hz RGB
60 Hz RGB
60 Hz RGB
60 Hz RGB
75 Hz RGB
85 Hz RGB
60 Hz IDTV (NTSC
60 Hz HDTV (Y/P
Number of memories
Memory numbers 00–99
(100 at maximum)
Four color temperature
settings (9300K/6500K/
5400K/3200K)
One for each projector
)
3.58
)
3.58
/P )
B R