Care Of Your Opener - Craftsman 139.18310D Owner's Manualanual

CARE OF YOUR OPENER

LIMIT AND FORCE ADJUSTMENTS:
Weather conditions may cause some
minor changes in door operation
requiring some re-adjustments,
particularly during the first year of
operation.
Pages 27 and 28 refer to the limit and
force adjustments. Only a screwdriver is
required. Follow the instructions
carefully.
Repeat the safety reverse test
(Adjustment Step 3, page 29) after
any adjustment of limits or force.
MAINTENANCE SCHEDULE
Once a Month
• Manually operate door. If it is unbalanced or binding,
call a trained door systems technician.
• Check to be sure door opens & closes fully. Adjust limits
and/or force if necessary (see pages 27 and 28).
• Repeat the safety reverse test. Make any necessary
adjustments (see Adjustment Step 3).
Once a Year
• Oil door rollers, bearings and hinges. The opener does
not require additional lubrication. Do not grease the door
tracks.
THE REMOTE CONTROL BATTERY
FORCE CONTROLS
9 9
1 1
7 3 7 3
5 5
KG
KG
The lithium battery should produce power for up to
LIMIT CONTROLS
5 years.
To replace battery, use the visor clip
or screwdriver blade to pry open the
case as shown. Insert battery
positive side up (+).
Dispose of old battery properly.
Replace the battery with only
3V2032 coin cell batteries.
32
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• Do NOT recharge, disassemble, heat above 100°C (212°F)
or incinerate.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Open this end
first to avoid
cracking
housing