■ Energy Conservation
When the camera is not in use for a long time, turn off the
power for safety and energy conservation reasons.
■ Copyright Protection
With the exception of the user being the copyright holder
or when permission such as for duplication has been
granted by the copyright holder, permission is required in
principle for the duplication, modification, or transmission
of copyrighted material.
Unauthorized duplication, modification, or transmission of
copyrighted material may constitute a copyright
infringement, and the user may be liable to compensate
for any damages. When using copyrighted material, be
sure to check the license agreement of the copyrighted
material thoroughly.
Preparation
Camera Installation
Disassembling the Camera
The following tools might help you to complete the installation:
Drill
Screwdrivers
Wire cutters
Seal Tape
Waterproof seal material (GE silicon)
All the installation and operations here should conform to your local electricity
Note
safety rules.
Gently remove the screw to take off camera housing (4).
Set the camera housing (5) and liner aside.
When rights or rights holders are involved with regard to
the targeted duplicating subject, permission may be
required for shooting or using (processing) it. Be sure to
check the licensing conditions thoroughly.
■ Disclaimer
We will not be responsible for any inconveniences or
disturbances caused in the event of privacy invasion as a
result of camera footages of this product.
■ Others
Because the camera controls auto exposure by shutter
speed, flicker can be shown by fluorescent light. To
reduce the flicker, please select PAL mode if the power is
50Hz, or NTSC mode if the power is 60Hz. (Refer to
INSTRUCTIONS "4 Overview of Navigation and Controls"
- "Video Type")
3