Replacement Procedure - Sanyo abc-vw24 Service Manual

Replacement Procedure

(1) How to Remove the Electrolyzing
Unit and Filter
1, Remove the lid and remove the
electrolyzing unit.
*If any water is spilt, wipe it up.
2, While pushing in the connection buttons
on the left and right of the main unit,
remove the front cover by pulling it
towards you.
3, Remove the prefilter and filter.
Lid (electrolyzing unit)
Tank (assembled)
Electrolyzing unit
Filter
Front cover
(2) How to Remove the Case (Back)
1, Remove the louver L setscrew in the tank
section and the 2 setscrews in the front
section and remove louver L.
2, Remove the 2 louver R setscrews and
remove louver R.
Louver L (air inlet left)
Louver R (air inlet right)
Fig - 1
Fig - 1
Fig - 1
Connection
buttons
Prefilter
Fig - 1
Photo - 2
Photo - 2
Louver setscrews
Photo - 2
- 16-
3, Remove the 2 setscrews on the cord
cover in the bottom section and remove
the cord cover.
Cord cover
4, Remove the 6 case (back) setscrews and
turn the main unit around.
Case (back) setscrews
5, Remove the case (back) setscrew at the
handle and the 3 setscrews at air
guide A.
6, Lift the bottom section of the case (back)
and remove the inset in the top section.
Remove the Control circuit C (switch)
connection through the gap and then
remove the case (back).
Case (back)
Case (back) setscrew
Air guide A setscrews
Case (back)
Control circuit C (switch) connector
ABC-VW24
Photo - 3
Cord cover setscrews
Photo - 3
Photo - 4
Photo - 4
Photo – 5
Photo - 5
Photo - 5