HP v1810g Quick Setup Manual

Download this manual

HP Switch Quick Setup Guide

For more detailed instructions and information, view or download the documentation for your switch at

www.hp.com/networking/support.

Unpack and check included parts:

• Switch

• Accessory kit

• Power cord

• Documentation kit

. Power on and verify selftest by connecting

the power cord.

Note: The switch does not contain a power switch.

It is turned on by connecting the power cord.

Install the switch.

To attach the mounting brackets to the switch, use a #1

Phillips (cross-head) screwdriver and the included 8-mm

M4 screws.

To mount the switch to a wall or wood surface, use two

5/8-inch (15.875 mm) number 12 wood screws (not

included).

Rack Mounting

Prepare for installation.

To avoid personal injury or product damage, review the

"Safety Precautions" on page 3.

After selftest:

Power LED = On

Fault LED = Off

Table or Desktop

Wall Mounting

Port LEDs

Page 1 HP Switch Quick Setup Guide For more detailed instructions and information, view or download the documentation for your switch at www.hp.com/networking/support. Unpack and check included parts: Prepare for installation. To avoid personal injury or product damage, review the • Switch “Safety Precautions”...
Page 2 Factory-default settings: Configure for operation on your network (minimal configuration). Parameter Factory Default Setting To change the factory-default settings: Password <blank> 1. Reconfigure a PC’s IP address and Subnet Mask so that it can communicate IP address 192.168.2.10 with the switch. For example, on a PC running Windows XP: Subnet mask 255.255.255.0 Click Start >...
Page 3 Ensure the air flow around the switch is not restricted. Leave at least 7.6 cm (3 inches) for cooling. For the air flow direction, see the Installation and Getting Started Guide for your product, located on the HP Web site at www.hp.com/networking/support.