Page 1
Harmonic distortion Less than 0.0035% Mass (approx.) 5.4 kg (11 lbs 15 oz) Supplied accessories Audio cord (2 phono plugs–2 phono plugs) (1) Output Remote commander (remote)(1) Sony SUM-3 (NS) batteries (2) Jack Maximum Load type output impedance level Design and specifications are subject to change without notice.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU PUBLISHED BY SONY.
Page 3
AEP Model : 842-2π return to chassis, must not exceed 0.5 mA (500 microampers). CDP-C460Z Leakage current can be measured by any one of three methods. US Model : 842-3π...
Page 4
http://www.jdwxzlw.com/?fromuser=华盛维修 CD-TEXT TEST DISC This unit is able to display the test data (character information) written in the CD on its fluorescent indicator tube. The CD-TEXT TEST DISC (TGCS-313:4-989-366-01) is used for checking the display. To check, perform the following procedure. Checking Method: Turn ON the power, set the disc on the disc table with the side labeled as “test disc”...
Page 5
http://www.jdwxzlw.com/?fromuser=华盛维修 Table 2: CD-TEXT TEST DISC Recorded Contents and Display (In this unit, some special characters cannot be displayed. This is no a fault.) TRACK Recorded contents Display ! ” # $ % & ’ (21h to 27h)1kHz 0dB L&R N All the same + , –...
Page 6
http://www.jdwxzlw.com/?fromuser=华盛维修 HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH TURNS OFF Insert a tapering driver into the aperture of the unit bottom, and turn in the direction of arrow (to OUT direction). * To close the disc tray, turn the driver in the reverse direction (to IN direction).
http://www.jdwxzlw.com/?fromuser=华盛维修 SECTION 2 DISASSEMBLY Note : Follow the disassembly procedure in the numerical order given. 2-1. CASE, BOTTOM PLATE AND FRONT PANEL 4 Case 1 Two screws (M3 × 8) 3 Two screws (BV3 × 8) !º Two screws (BVTT3 × 8) 9 Flat type wire (9 core) 2 Two screws (MAIN board, to CN403)
http://www.jdwxzlw.com/?fromuser=华盛维修 SECTION 3 ELECTRICAL BLOCK CHECKING Note : Note : A clear RF signal waveform means that the shape “ ◊ ” can CD Block is basically designed to operate without adjustment. Therefore, check each item in order given. be clearly distinguished at the center of the waveform. Use YEDS-18 disc (3-702-101-01) unless otherwise indicated.
CDP-C460Z/CE515 SECTION 4 DIAGRAMS RF PLL Free-run Frequency Check Adjustment Location : 4-1. CIRCUIT BOARDS LOCATION Procedure : [ BD BOARD ] — Conductor Side — Connect frequency counter to test point TP (PLCK) with lead wire. frequency counter...
http://www.jdwxzlw.com/?fromuser=华盛维修 4-9. IC PIN FUNCTIONS • IC101 DIGITAL SIGNAL PROCESSOR (CXD2545Q) Pin No. Pin Name Function SRON Sled drive output (Not used) SRDR Sled drive output SFON Sled drive output (Not used) TFDR Tracking drive output TRON Tracking drive output (Not used) TRDR Tracking drive output TFON...
Page 20
http://www.jdwxzlw.com/?fromuser=华盛维修 Pin No. Pin Name Function — Digital power supply ASYE Asymmetry circuit ON/OFF PSSL Audio data output mode selection input WDCK 48-bit slot D/A interface. Word clock. LRCK 48-bit slot D/A interface. LR clock. DATA DA 16 output when PSSL=1.48-bit slot serial data when PSSL=0 BCLK DA 15 output when PSSL=1.48-bit slot data when PSSL=0 64DATA...
Page 21
http://www.jdwxzlw.com/?fromuser=华盛维修 Pin No. Pin Name Function XRST System reset DIRC Used in 1-track jump mode (+5v) SCLK SENS serial data read-out clock DFSW DFCT selection pin (Ground) ATSK Input pin for anti-shock (Ground) DATA Serial data input, supplied from CPU XLAT Latch input, supplied from CPU CLOK...
http://www.jdwxzlw.com/?fromuser=华盛维修 5-2. BACK PANEL AND DISC TABLE SECTION supplied M801 supplied US, CND MODEL AUS MODEL AEP MODEL not supplied not supplied not supplied not supplied Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks 4-957-299-11 TABLE (B), DISC 4-988-162-01 ROLLER 4-957-304-01 BELT (RM) 4-934-376-01 SHAFT (ROLLER)
http://www.jdwxzlw.com/?fromuser=华盛维修 SECTION 6 ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • RESISTORS When indicating parts by reference number, parts list may be different from the parts All resistors are in ohms. please include the board naame. specified in the diagrams or the components METAL: metal-film resistor The components identified by mark ! or...
Page 30
http://www.jdwxzlw.com/?fromuser=华盛维修 LOADING MOTOR MAIN Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks < RESISTOR > C502 1-163-243-11 CERAMIC CHIP 47PF C503 1-163-243-11 CERAMIC CHIP 47PF R711 1-249-415-11 CARBON 1/4W F C504 1-106-359-00 MYLAR 4700PF 200V (CE515) C505 1-130-472-00 MYLAR 0.0012uF 5%...
Page 31
http://www.jdwxzlw.com/?fromuser=华盛维修 MAIN Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks < IC > < RESISTOR > IC301 8-759-362-47 IC CXD8567AM R205 1-216-075-00 METAL CHIP 1/10W IC302 8-752-886-46 IC CXP84340-060Q R206 1-216-073-00 METAL CHIP 1/10W IC303 8-759-374-72 IC LC35256AM-10 R251 1-216-073-00 METAL CHIP 1/10W...
Page 32
http://www.jdwxzlw.com/?fromuser=华盛维修 MAIN POWER SW SENSOR Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks R410 1-216-053-00 METAL CHIP 1.5K 1/10W < VIBRATOR > R411 1-216-105-00 METAL GLAZE 220K 1/10W R412 1-216-047-00 METAL GLAZE 1/10W X301 1-579-834-11 VIBRATOR, CRYSTAL 33MHz R413 1-216-033-00 METAL CHIP 1/10W...
Page 33
http://www.jdwxzlw.com/?fromuser=华盛维修 TABLE MOTOR Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks 1-647-364-11 TABLE MOTOR BOARD ACCESSORIES & PACKING MATERIALS ****************** ******************************** < MOTOR > 1-475-088-11 REMOTE COMMANDER (RM-DC53) 1-558-271-11 CORD, CONNECTION (AUDIO) 1-777-241-11 CORD, CONNECTION (CONTROL A1)(CND) M801 A-4660-525-A MOTOR ASSY, ROTARY (TABLE) 3-810-765-33 MANUAL,COMMONNESS INSTRUCTION...