Sony Trimaster EL PVM-2541 Operating Instructions Manual page 67

Submenu Setting
PARALLEL REMOTE Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – ("– – –": No function is
• COMPOSITE
• HDMI
• SDI 1
• SDI 2
• WFM/ALM
• OVERSCAN
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R
• TALLY G
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• MARKER MAT HALF
• SAFE AREA 80%
• SAFE AREA 85%
• SAFE AREA 88%
• SAFE AREA 90%
• SAFE AREA 93%
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 70.
• Set MARKER ENABLE
(page 63) to ON to control the
aspect marker and center
marker.
assigned.)
Submenu Setting
FORCED TALLY The tally lamp function is forcibly
assigned to 7 pin and 8 pin of the
PARALLEL REMOTE connector.
Selecting ON assigns tally lamp
green to 7 pin and tally lamp red to
8 pin.
Note
When OFF is selected, any listed
functions can be assigned to 7 and 8
pins. Selecting ON with any
function other than the tally lamp
assigned to 7 and 8 pins will ignore
this setting, and the tally lamp is
forcibly assigned to 7 and 8 pins
instead.
ON: Forcibly assigns the
tally lamp function.
OFF: The tally lamp
function is not forcibly
assigned.
67
Adjustment Using the Menus