Hitachi CC 14SF Handling Instructions Manual page 25

English
7. Service parts list
CAUTION
Repair, modification and inspection of Hitachi Power
Tools must be carried out by an Hitachi Authorized
Service Center.
This Parts List will be helpful it presented with the
tool to the Hitachi Authorized Serivde Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Acccordingly, some parts may be changed without
prior notice.
NOTE
Due to HITACHI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
Information concerning airborne noise and vibration
The measured values were determined according to
EN61029.
The typical A-weighted sound pressure level: 97 dB (A)
The typical A-weighted sound power level: 109 dB (A)
Wear ear protection.
The typical weighted root mean square acceleration
2
value: 1.2 m/s .
Information about power supply system of nominal
voltage 230 V~
Under unfavorable mains conditions, this power tool
may cause transient voltage drops or interfering voltage
fluctuations .
This power tool is intended for the connection to a
power supply system with a maximum permissible
system impedance Z
MAX
point (power service box) of the user's supply.
The user has to ensure that this power tool is connected
only to a power supply system which fulfills the re-
quirement above.
If necessary, the user can ask the public power supply
company for the system impedance at the interface
point.
Information about the circuit-breaker swtich of
nominal voltage 230V~
This tool should be used only if it is connected to a
16A Fuse with gl disconnection characteristic.
24
of 0.14 Ohm at the interface