Panasonic NC-ZA1 Operating Instructions Manual page 17

2
Turn the power on.
Plug in and press the power button.
1
• Make sure the waste container, water tank, drip tray and stainless steel plate are fitted.
• Open the drip tray by pressing it. (Attention for drip tray display will show for 3 seconds after the espresso machine is
heated up.)
Heats up the machine
automatically.
Press to start rinsing.
2
• Make sure the drip tray is opened. Otherwise hot water will dispense onto the countertop.
When rinsing is complete (dispense hot
water 4 times), the display will return to
the main menu. Wait until the display
shows the main menu.
Note
• When starting up for the first time or when the water tank was
completely emptied, water suction may take a little longer dispensing
hot water for rinsing cycle.
• A small amount of water can get into the waste container during each
rinsing cycle. This is system-related and not a fault.
• If is pressed during the rinsing cycle, it immediately stops
the process.
After flashes, the display will return to the previous display.
• When dispensing hot water into the drip tray during rinsing cycle, you
may place the container under the dispenser.
• During the rinsing, water is to collect in the drip tray.
When water is full in the drip tray, the red float will be float up.
Float
GB17