Installation
Four M5 socket screws are supplied for
aligning and securing the machine in its
niche.
Open the front of the machine and
loosely fit the screws at either side.
Carefully turn the lower socket
screws to centre the machine in the
niche.
Tighten both upper socket screws by
hand to secure the machine in the
unit. Do not overtighten them.
92
Adjusting the hinges
If the machine front becomes difficult to
open or close after installation, you can
adjust the hinges to realign it (TX 20):
Tighten screw to align the front of
the machine so that it is flush with
the front of the housing unit.
Tighten screw to align the front of
the machine horizontally and
vertically.