Installation Site - Electrolux EPI09LEIW User Manual

15 www.electrolux.com

The outdoor unit is powered by the
indoor unit.

This air conditioner uses R410A
refrigerant

7.2. Installation site


Do not install the unit in areas with:
- strong heat sources;
- vapours or flammable gasses;
- contamination with oil particles;
- high frequency electromagnetic
equipment (e.g. welding equipment or
medical devices);
- high salinity (e.g. close to coastal
areas);
- sulphuric gas (e.g hot water springs);
- poor air quality.
Indoor unit

Maintain the minimum installation
distances specified in this document.
Do not block the air inlet or the air
outlet.

Do not use the unit in places with
extremely high humidity.

Install the indoor unit out of reach of
children.

The wall must be strong enough to
support the weight and vibration of
the unit.

Install the indoor unit at least 230 cm
above the floor surface.

Leave sufficient space for cleaning
and maintenance.

The air filter should remain accessible.

Leave at least 1 m distance between
the unit and other electrical
appliances.

Install the indoor unit in a place where
the condensate water can be seaily
drained.

Install at a location protected from
direct sunlight.
Outdoor unit

Maintain the minimum installation
distances specified in this document.

Do not block the air inlet or the air
outlet.

Install the outdoor unit out of reach of
children.

Install the outdoor unit where there is
sufficient ventilation.

Install the outdoor unit where
produced noise and airflow will not
disturb neighbors or animals.

Install the outdoor unit in a dry place.

Install the outdoor unit in a place not
exposed to direct sunlight or strong
wind.

Install the unit in a place that supports
the weight and vibration of the unit.

The height difference between the
indoor unit and the outdoor unit must
be less than 5 m.

The length of the connecting pipes
must be less than 10 m.

Leave sufficient space for cleaning.

The outdoor unit is powered by the
indoor unit.
Safety precautions for electrical
appliances

Use a dedicated mains circuit.

The unit must be properly grounded.

Install a Residual-current device
(RCD) to protect against personal
injury in case of leakage currents.

Use an all pole disconnection switch
with a contact separation of at least 3
mm in all poles in fixed wiring. For
models with a mains plug, make sure
that the mains plug is within reach
after installation.

The installation must comply with
local electrical safety regulations and
with other relevant local regulations

The unit must be installed in
accordance with national wiring
regulations.

Do not subject the mains cable to
force.