Change The Parameter Setting Value; Setting Dial Push - Mitsubishi Electric F700 Instruction Manual

Operation panel (FR-DU07)
4.1.3

Change the parameter setting value

Changing example Change the Pr. 1 Maximum frequency .
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Press
setting mode.
4.
5.
Press
" "(initial value) appears.
6.
Turn
value "
7.
Press
to
appears. ...... Write disable error
appears. ...... Write error during operation
appears. ...... Calibration error
appears. ..... Mode designation error
For details refer to page 236.
REMARKS
⋅ The number of digits displayed on the operation panel (FR-DU07) is four. Only the upper four digits of values can be displayed
and set. If the values to be displayed have five digits or more including decimal places, the fifth or later numerals can not be
displayed nor set.
(Example) When Pr.1
When 60Hz is set, 60.00 is displayed.
When 120Hz is set, 120.0 is displayed. The second decimal places can not be displayed nor set.
4.1.4

Setting dial push

Push the setting dial (
58
Operation
to choose the PU operation
to choose the parameter
Pr. 1) appears.
to read the currently set value.
to change it to the set
".
to set.
· By turning , you can read another parameter.
· Press to show the setting again.
· Press twice to show the next parameter.
· Press twice to return the monitor to frequency monitor.
are displayed ... Why?
) to display the set frequency currently set.
Display
PU indication is lit.
Flicker ··· Parameter setting complete!!
The parameter
number read
previously appears.