Sony VPL-CX61 Protocol Manual page 46

<Table 1>
Item Number
Item
Status Error
Status Power
Control Mode Select
Lamp Timer
ROM Version
SC ROM Version
*3
Status Security
Channel Memory Reset
Status Memory Reset
Set Memory Reset
W/B All Save
W/B Low Save
W/B High Save
Sircs (15 Bit Category)
Sircs (20 Bit Category)
Item Number
Item
ACK
NAK Undefined Command
Size Error
Select Error
Range Over
Not Applicable
Check Sum Error
Framing Error
Parity Error
Over Rub Error
Other Comm Error
42
VPL-CX61/CX63/CX75/CX76/CX80/CX85/CX86/CX100/CX120/CX125/CX150/CX155/CW125/FE40/FE40L/FH300L/FX40/FX40L/FX51/FX52/FX52L/FW300L/PX35/PX40/PX41
(VPL-CX61, CX63)
Upper byte Lower byte
01h 01h
01h 02h
01h 05h
01h 13h
01h 1Dh
01h 1Eh
01h 1Fh
03h 01h
02h
03h
04h
05h
06h
17h Refer to table 16
19h Refer to table 17
(VPL-CX61, CX63)
<Table 3>
Data Upper byte
_
00h
01h
F0h
<Table 2>
Data
Data Upper byte
No Error
Lamp Error
Fan Error
Cover Error
Temp Error
D5V Error
Power Error
Warning Error
Standby
Start Up
Startup Lamp
Power On
Cooling1
Cooling2
Saving Cooling1
Saving Cooling2
Saving Standby
User Mode
Service Mode
Lamp Use Time 0000h-FFFFh
MAIN ROM Version
SC ROM Version
Disable
Enable
_
_
_
*1 Example) In case the lamp timer indicates 1000H,
return values are [03h] upper byte and [E8h] lower
byte.
*2 Example) In case the software version is 1.03, return
Data
values are [01h] upper byte and [03h] lower byte.
*3 While the set is security locked, after power switch
Lower byte
is turned on, you can check that pass sword input
00h
screen is indicated or not.
During pass word input screen indicating, return
01h
values are [00h] upper byte and [01h] lower byte.
04h
*4 It is corresponded to single command only.
05h
06h
The await-return time of return value is approx. 50 msec.
m
0Ah
. This is the case, unless the communications are
10h
interfered anyway.
. If standby mode is set as "low", the main part of a
20h
projector will go into power-saving mode in about 1
30h
minute after standby.
A command is executed by resending, although "Not
40h
Applicable" will return, if a command is sent into power-
50h
saving mode.
Lower byte
00h 00h
00h 01h
00h 02h
00h 04h
00h 08h
00h 10h
00h 20h
00h 40h
00h 00h
00h 01h
00h 02h
00h 03h
00h 04h
00h 05h
00h 06h
00h 07h
00h 08h
00h 00h
00h 01h
*1
*2
*2
00h 00h
00h 01h
00h 00h
00h 00h
00h 00h
Remarks
Get only
Set only
Set only *4