Assembly; Electrical Safety; Mounting Accessories; Use - Black & Decker PD1200AV Dustbuster Original Instructions Manual

Hide thumbs Also See for PD1200AV Dustbuster:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
These include:
Injuries caused by touching any mov-
u
ing parts.
Injuries caused by touching any hot
u
parts.
Injuries caused when changing any
u
parts or accessories.
Injuries caused by prolonged use of
u
the appliance. When using any appli-
ance for prolonged periods ensure you
take regular breaks.

Electrical safety

The appliance is designed for use with
12V negative ground vehicle battery
systems.
Warning! The cigarette lighter connec-
tor is fitted with a non-serviceable safety
fuse. The fuse may operate in the event
of a fault. If this occurs the fuse must be
replaced together with the connector and
cable by the manufacturer or an author-
ised Black and Decker Service Centre in
order to avoid a hazard.
Warning! Do not operate the appliance
with systems which have positive ground
or a different voltage.
Features
This appliance includes some or all of the following features.
1. On / Off switch
2. Removable handle
3. Handle release ring
4. Hose
5. Transparent door
6. Cigarette lighter connector
7. Door latch
8. Bowl release button
9. Removable dust bowl
10. Accessory clip
11. 2-in-1 combi nozzle accessory
12. Crevice tool.
(Original instructions)

Assembly

Mounting accessories (fig. B, C, D, E,
F & G)
The 2-in-1 combi nozzle (11) has a brush that can be folded
forward for dusting and upholstery cleaning
To fit an accessory press the accessory clip (10) and slide
u
the accessory onto the handle (2) (Fig. B & C).
To remove an accessory, press the accessory clip (10) and
u
remove the accessory.
The handle (2) can be removed from the hose (4) allowing
the accessories to be connected directly to the hose when
required. To remove the handle:
Unclip the handle (2) from the appliance.
u
Rotate the locking ring (3) anti-clockwise to release the
u
clips (Fig. D).
Pull the hose (4) away from the handle (2) (Fig. E).
u
Fit the accessory directly to the hose cuff (3) (Fig. F)
u
To refit the handle:
Remove the accessory from the hose.
u
Push the hose (4) into the handle (2). Rotate the locking
u
ring (3) clockwise until it clicks into place

Use

Connecting to the vehicle's power
supply
Make sure that the appliance is switched off.
u
Remove the cigarette lighter from it's socket.
u
Plug the connector (6) into the cigarette lighter socket.
u
Switching on and off (fig. A)
To switch on, slide the on/off switch (1) to the right.
u
To switch off, slide the on/off switch (1) to the left until it
u
clicks into the off position.
The appliance can be used for periods of up to 30 minutes
without noticeably affecting the power of a normally charged
car battery in good condition.
Warning! Extended use will drain the battery power. Do not
run the vehicle's engine while cleaning as this can shorten the
life of the appliance.
Vacuuming
When operating the appliance, make sure that the hose is
u
not trapped, twisted or blocked.
The handle (2) can be easily removed from the appliance
u
allowing you to reach up to 1.5 m from the appliance.
With the handle (2) removed, the appliance can be carried
u
using the built-in handle.
ENGLISH
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents