Replacing The Battery/Set The Date And Time - Panasonic DP-8020E Operating Instructions Manual

The machine has an internal battery
(Product No.: CR2032) which maintains
the date and time.
In the event the battery requires
replacement, the following message will
be displayed.
REPLACE BATTERY
When setting the Date and Time, start
from step 6.
■ Notice: California only:
This product contains a CR Coin Cell Lithium Battery which contains
Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
NOTE
80
Downloaded From ManualsPrinter.com Manuals
Problem Solving

Replacing the Battery/Set the Date and Time

1
U90
Set the Date and Time continues steps 6 to 13.
6
10
● The service life of the battery is approximately 1 year under normal use.
Turn the Power Switch on
the Right Side of the
machine to the OFF
position.
If the Hard Disk Drive Unit
(DA-HD18) is installed, see
page 13.
09 KEY OPERATOR MODE
ENTER PASSWORD=
3-digit
(See page 13)
2
Battery Holder
Remove 1 Screw.
Remove the Battery Holder.
11
KEY OPR.MODE (00-34)
ENTER NO. OR
∨ ^
or
17 (DATE & TIME)