Function Button Setting - Sony PVM-740 Operating Instructions Manual

Submenu Setting
POSITION Sets the position of the WFM/ALM
display. You can select from among 1 to
4.
• 1: Bottom left
• 2: Bottom right
• 3: Top right
• 4: Top left

FUNCTION BUTTON SETTING

USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
F 5 B U T T O N :
F 6 B U T T O N :
F 7 B U T T O N :
Submenu Setting
F1 BUTTON to F7 Assigns the function to the function
BUTTON buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE and
WFM/ALM.
Factory setting
• F1 button: BRIGHTNESS
• F2 button: CONTRAST
• F3 button: CHROMA
• F4 button: SCAN
• F5 button: H/V DELAY
• F6 button: VOLUME
• F7 button: I/P MODE
About the function assigned to the
function button
SCAN
Press the button to change the scan size of the picture.
With every press of the button, the picture switches in
the sequence NORMAL scan t OVER scan t
NATIVE (see "Scan mode image" on page 59).
ASPECT
Press the button to set the aspect ratio of the picture, 4:3
or 16:9.
BLUE ONLY
Press the button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
signal noise.
58
Adjustment Using the Menus
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
MONO
Press the button to display a monochrome picture. When
the buttons is pressed again, the monitor switches
automatically to color mode.
MARKER
Press the button to display the marker. Set the aspect
marker in the MARKER SETTING menu (see page 56).
H/V DELAY
Press the button to observe the horizontal and vertical
sync signals at the same time.
WFM/ALM
Press the button to display the WFM/ALM display. Set
the WFM/ALM display setting in the WFM/ALM
DISPLAY SETTING menu (see page 57).
BRIGHTNESS
Press the button to adjust the picture brightness. Press
the button to display the adjustment screen and adjust
the picture brightness. Press again to hide the adjustment
screen. However, the picture brightness remains
adjustable. Turn the menu selection control right to
increase the brightness and turn left to decrease it.
CONTRAST
Press the button to adjust the picture contrast. Press the
button to display the adjustment screen and adjust the
picture contrast. Press again to hide the adjustment
screen. However, the picture contrast remains
adjustable. Turn the menu selection control right to
increase the contrast and turn left to decrease it.
CHROMA
Press the button to adjust the color intensity. Press the
button to display the adjustment screen and adjust the
color intensity. Press again to hide the adjustment
screen. However, the color intensity remains adjustable.
Turn the menu selection control right to increase the
intensity and turn left to decrease it.
VOLUME
Press the button to adjust the volume. Press the button to
display the adjustment screen and adjust the volume.
Press again to hide the adjustment screen. However, the
volume remains adjustable. Turn the menu selection
control right to increase the volume and turn left to
decrease it.
I/P MODE
Press the button to set the delay by the picture
processing to the minimum level when interlace signal
is input. The mode switches in the sequence INTER-
FIELD t FIELD MERGE t LINE DOUBLER with
every press of the button (see "I/P MODE" on page 56).