tank, or with the outboard motor in the water.
1.
Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly.
2.
Once the engine has warmed up, verify
whether the idle speed is set to specifi-
cation. For idle speed specifications, see
page 9. If you have difficulty verifying the
idle speed, or the idle speed requires ad-
justment, consult a Yamaha dealer or
other qualified mechanic.
EMU29061
Checking water in engine oil tank
A translucent water drain hose is connected
from the bottom of the oil tank to the filler
neck. If water or foreign matter collects in this
hose, consult a Yamaha dealer.
1
1. Drain hose
2. Filler neck side
1
1. Drain hose
2
ZMU03416
2
ZMU04989
2. Filler neck side
EMU29114
Inspecting wiring and connectors
Inspect that each connector is engaged
●
securely.
Inspect that each ground lead is properly
●
secured.
EMU32112
Checking propeller
EWM01881
WARNING
You could be seriously injured if the en-
gine accidentally starts when you are
near the propeller. Before inspecting, re-
moving, or installing the propeller, place
the shift control in neutral, turn the main
switch to "
" (off) and remove the key,
and remove the clip from the engine shut-
off switch. Turn off the battery cut-off
switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Put a wood block between the anti-cavi-
tation plate and the propeller to prevent the
propeller from turning.
Maintenance
ZMU03240
75