NEC AccuSync LCD22WMGX User Manual page 7

Figure C.1
LCD22WMGX
RCA
RCA
HDMI Connector
LCD24WMCX
HDMI Connector
Figure TS.1
LCD22WMGX
Non-abrasive surface
Figure R.1
Figure R.2
01_English
Power Button
Amplifier
To Audio
External Speakers
Left Audio
Right Audio
RCA
DVD
From HDMI Output
Amplifier
To Audio
RCA
External Speakers
RCA
RCA
Right Audio
Left Audio
DVD
From HDMI Output
Figure D
LCD24WMCX
3
5. Turn on the monitor with the front power button and the computer
(Figure C.1).
6. Select input source by Source button or Input Select on OSD
menu.
7. No-touch Auto Adjust automatically adjusts the monitor to optimal
settings upon initial setup for most timings.
For further adjustments, use the following OSD controls:
• Image Setup
Refer to the Controls section of this User's Manual for a full
description of these OSD controls.
NOTE: If you have any problem, please refer to the
Troubleshooting section (CD-ROM).
Connecting to DVD player, Stereo Amplifier
1. Turn off the power to the monitor.
2. For the DVD player with component out: Connect the
Component connecter (RCA) on the LCD monitor, use a
separately available RCA connector cable (Figure D).
For the DVD Player with HDMI out: Connect HDMI cable to the
DVD player (Figure D).
NOTE: Refer to your DVD player user's manual for more
information.
For the Stereo Amplifier: Connect HDMI cable to the DVD
player. Connect the stereo RCA cable to the SPDIF (COAXIAL)
connector on the LCD monitor and the audio input on the amplifier
(Figure D).
NOTE: Refer to your amplifier user's manual for more information.
3. Keep all cables together and attach the Cable Holder into the
Base.
4. Connect the power cord to the power outlet.
5. Turn the monitor on using the front power button.
6. Select input source by Source button or Input Select on OSD
menu.
NOTE: If you have any problem, please refer to the
Troubleshooting section (CD-ROM).
Tilt
Grasp both sides of the monitor screen with your hands and adjust
the tilt as desired (Figure TS.1).
Remove Monitor Stand for Mounting
To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (Figure R.1).
3. Remove the 3 screws connecting the monitor to the stand and
remove the stand as indicated (Figure R.1).
The monitor is now ready for mounting in an alternative manner.
4. Connect the AC cord to the back of the monitor (Figure R.2).
5. Reverse this process to re-attach stand.
NOTE: Use only VESA-compatible alternative mounting method.
NOTE: Handle with care when removing monitor stand.
Removing the Base
NOTE: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-
abrasive surface (Figure R.1).
2. While using your thumbs, press the
bottom tabs upward to unlock.
3. Press the top tabs down to unlock
and pull off the stand.
English-3
25/9/07, 12:15 PM
Tab