Brother DCP-9015CDW Product Safety Manual page 4

DO NOT put the product in a location that blocks or obstructs any slot or opening in the product.
These slots and openings are provided for ventilation. Blocking the product's ventilation could
create a risk of overheating and/or fire.
Instead:
• Keep a gap of at least 150 mm between the ventilation hole and the wall.
• Place the product on a solid level surface.
• DO NOT place this product near or over a radiator or heater.
• DO NOT place this product in a "built-in" installation unless adequate ventilation is provided.
CAUTION
This product emits some chemical substances during printing, and additionally if used for
prolonged periods or in poorly ventilated areas may cause the emission of odorous gases such
as ozone. Place the product in a well ventilated area for optimum performance and comfort.
Avoid placing your product in a busy area. If you must place it in a busy area, ensure that the
product is in a safe location where it cannot be accidentally knocked over, which could cause
injury to you or others and serious damage to the product. Also ensure that cords are secured
so as not to pose a tripping hazard.
DO NOT connect your product to electrical sockets controlled by wall switches or automatic
timers, or to the same circuit as large appliances, such as an air conditioner, copier, shredder,
etc. that might disrupt the power supply.
DO NOT eat the silica gel pack, please throw it away. If ingested seek medical attention
immediately.
DO NOT place heavy objects on the product.
DO NOT place this product on an unstable cart, stand, or table. The product is heavy and may
fall, causing injury to you and serious damage to the product. For MFC and DCP products, there
is an added risk of injury if the scanner glass should break. Particularly, if you have children,
please make sure the product is located in a safe position.
4