Getting Started; Assembling Your Steam Mop - Sharp S7000UK Owner's Manual

Getting Started

When assembling your steam mop there may be a little water in or around the water tank. This is because we test all
our steam mops 100% before you buy them, so you get a quality Shark
a
b
c
d
e
f
g
h
i
a
Mop Handle
b
Cord Clip
(XBTECLP03)
c
Water Tank Cap
d
Handheld Steamer
e
Power Button
f
Release Button
g
Rectangle Mop Head
(3072SO7000)
h All Purpose Cleaning Pad for Rectangle Head (x2)
i
Carpet Glider
(XCG7000)
5 0800 862 0453
® Multi-Function Steam Mop Lite.
j
k
l
m
n
j
Concentrator Nozzle
(3011FO2901)
k
Accessory Hose
(3010FO2901)
l
Grout Scrubber Brush
(1081SO)
m
Window Squeegee
(1078SO)
n
Filling Flask
(1039SO)
(P159W)

Assembling Your Steam Mop

fig. 1
IMPORTANT: Always make sure the mop is
UNPLUGGED from the wall when not in use. Never
fill the mop, attach the mop head, change or remove
the cleaning pad when the mop is plugged into the
wall. To prolong the life of your Shark ® Multi-Function
Steam Mop Lite we recommend using distilled water.
Make sure you only add water to the tank. Chemicals
or cleaning solution may damage the appliance and
could be unsafe for you and your family.
fig. 2
STEAM MOP ASSEMBLY
1
Insert the Mop Handle end with the " " facing the
front of the unit into the handheld steamer. Push the
mop handle in until you hear it click into place. (fig. 1)
2 Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place. Press the release button to
remove or change the mop head. (fig. 2)
3
Place the cleaning pad on the floor with the logo
side facing up. Place the Shark ® Multi-Function
Steam Mop Lite on top of the pad to attach.
www.sharkclean.eu 6