Honeywell DCP 50 Product Manual page 80

APPENDIX C
The lower display on the Controller Programmer front panel is used to identify the
parameter being displayed. The parameter identifiers are as follows:
Legend
Manual Power (xxx = power output value)
Setpoint
Delayed Start
Final (Target) Setpoint for Segment xx (01 - 16)
Time remaining
Cycles remaining
Automatic/Manual Control selection
Event/Alarm Status
Current Program (1 - 4)
Input Filter Time Constant
Process Variable Offset
Output 1 Power (0 - 100%)
Output 2 Power (0 - 100%)
Proportional Band 1
Proportional Band 2
Reset (Integral Time Constant)
Rate (Derivative Time Constant)
Deadband/Overlap
Bias (Manual Reset)
ON/OFF Differential (both outputs)
ON/OFF Differential (Output 1 only)
ON/OFF Differential (Output 2 only)
Setpoint Lock
C-1
SUMMARY OF DISPLAYS
Meaning
Base Mode Parameters
Controller Set-Up Mode Parameters
Section
1.12
1.1
1.2
1.6
1.6
1.6
1.6
1.6
1.6
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1
4.1