If You Do Not Use A Dedicated Primary Cluster Protocol Network; Upgrading Ipso In A Cluster - Nokia IPSO 4.0 Reference Manual

If You Do Not Use a Dedicated Primary Cluster Protocol Network

If your primary cluster protocol network also carries production traffic, IPSO's cluster protocol
messages are propagated throughout the production networks. This happens whenever you use
the same physical links for cluster protocol traffic and production traffic--that is, it occurs even if
you use VLANs (trunking) to segregate the traffic. This is an unproductive use of bandwidth
because cluster protocol messages are used only by IPSO cluster nodes.
You can prevent the cluster protocol messages from being spread across the production networks
by using multicast mode with IGMP and connecting the networks with switches that use IGMP
snooping. You usually need to enable IGMP for specific switch ports or VLANS. (See
"Clustering Modes"
IPSO sends out IGMP membership reports for the cluster protocol multicast group. A switch
using IGMP snooping will then forward cluster protocol messages only to group nodes—that is,
the other cluster nodes. It will not forward the cluster protocol traffic to ports that are not
connected to cluster nodes.
The ideal configuration is to physically separate the production and primary cluster protocol
networks (connect them using different switches). If you configure a cluster this way, the cluster
protocol messages will not appear on your production networks even if the switches on the data
networks do not support IGMP snooping. This configuration is preferable to using separate
VLANs on one switch to separate the networks.
Caution
Do not use a secondary cluster protocol network for production traffic. If a secondary
cluster protocol network fails but the primary remains functional, the cluster remains
active but traffic to non-cluster devices on the secondary network might fail.

Upgrading IPSO in a Cluster

This section explains how to create and configure an IPSO cluster. It includes information about
upgrading from IPSO 3.6 if you have created clusters with 3.6 and also explains how to add
nodes to a cluster.
Nokia Network Voyager for IPSO 4.0 Reference Guide
dropped in the event that there is a failover. The ADP I/O ports should be used for
production traffic.
You can aggregate the ports on ADP I/O cards and use the aggregated links for
production traffic. If you aggregate ports on ADP I/O cards, observe the following
guidelines:
You can connect the aggregated ports using a switch, hub, or crossover cable.
Do not include ports on different ADP I/O cards in the same aggregation group.
Do not combine any of the built-in 10/100 Ethernet management ports with ports on
an ADP I/O card to form an aggregation group.
for more information about multicast mode with IGMP.)
217