Page 1
Service Manual Ventilating Fan WhisperSense (North America Market) FV-08VQCL5 FV-11VQCL5 WARNING This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
2.Parts Identification FV-08VQCL5 FV-11VQCL5 (2pcs) (2pcs) Motor Unit Capacitor Box (3pcs) Section (4pcs) (Motor Lead) Cord Clip White White (Motor Lead) (Cord) (6pcs) White (Motor Lead) Binder Tie (4pcs) Black (Motor Lead) Black (Cord) Details Of Wiring Section Capacitor Box Section...
Page 4
2.Parts Identification FV-08VQCL5 FV-11VQCL5 Ballast Assembly Replacement Method If the ballast assembly was damaged,please order the new grille unit section(FFV3420058S) to replace defective ballast assembly&original grille unit.Please refer to P12-P14 for replacement guide. Remark:The minimum quantity of an order for this new grille unit is 10 sets.
Page 5
2.Parts Identification FV-08VQCL5 FV-11VQCL5 (36) LISTEN 8B68 A375682G8 Main Labels Main Packing Materials (Stuck On Frame Assy)
FFV0900048S Connector Plate FFV0900049S Connector Assembly V FFV3402103S Earth Lead Wire Assembly FFV2800012S Junction Cover FFV0760028S Capacitor Box 10 FFV3702217S Motor Assembly For FV-08VQCL5 (10) FFV3702215S Motor Assembly For FV-11VQCL5 11 FFV3730086S Motor Support 12 FFV0400103S Blade 13 FFV7020021S Nut...
Page 8
51 FFV4710210S Grille Case Assembly 52 FFV4710344S Right Pad 53 FFV4710345S Left Pad 54 FFV4710330S Sensor Pad 55 FFV9000985S Packing Case Assembly For FV-08VQCL5 (55) FFV9000986S Packing Case Assembly For FV-11VQCL5 56 FFV2540164S Installation Instruction 57 FFV0010230S Accessory A 58 FFV0730032S Cord Assembly B...
Page 9
5.Replacement Guide INSTALLATION Ceiling WARNING Mounting spring Plug connector Disconnect power source before working on unit. Claw 1. Remove the primary light kit grille by pulling down one mounting spring, remove sensor unit and remove plug connector Ⅰ ,then pull down the other mounting spring (Squeeze mounting spring and pull down sensor unit carefully) (Fig.1)
Page 10
5.Replacement Guide INSTALLATION 6. Install the night lamp and fluorescent lamps. Fluorescent (Fig.6) lamp 7. Install light kit cover assembly. (Fig.7) 8. Insert the grille mounting spring on the wiring side into the slot and insert the plug connector into the housing of the lighting unit.(Fig.8) Night lamp Fig.6 CAUTION...
Page 11
5.Replacement Guide MAINTENANCE(REPLACEMENT OF LAMP) Ceiling WARNING Plug connector lighting unit Disconnect power source before working Gloves on unit. This is a pin type lamp base and the lamp’s Grille glass is fragile.To remove,pull out carefully. Claw Insert Plug connector 4W night lamp has threaded base,Remove Fig.1 by turning counterclockwise.