Table of Contents
Advertisement
Speaker and Sub Woofer Set Up
Settings required for surround sound
— SET UP
The speaker set up consists of two items: the connection
status and the distance from the listening position to the
speakers. Be sure to follow the procedure below to set the
connection status. If the connection status is not set
correctly, sound may not come from the speakers.
When you want to obtain more accurate surround effects,
set the distance to the speakers.
2
3,6
1
Make sure the SPEAKER SELECTOR switch on the
rear panel of the processing amplifier is set to
"FRONT".
2
Turn on the processing amplifier.
The ON-STANDBY indicator above the 1/u button on
the processing amplifier goes off.
3
Press SET UP.
The SET UP button lights and "SPEAKER SETUP"
appears in the display.
4
Set the center speaker connection status.
1 Press CURSOR
V
v
/
repeatedly until "CENTER
*
[LARGE
]" appears in the display.
2 Press CURSOR
B
b
/
to select the center speaker
connection status.
Center speaker connection status
None
Connected
Normal
If the sound is distorted
*
The last setting is stored in the memory, so [SMALL] or
[NO] may appear instead.
EN
20
5
Set the sub woofer connection status.
1 Press CURSOR
2 Press CURSOR
4,5
*
The last setting is stored in the memory, so [NO] may
appear instead.
6
To enjoy more accurate surround effects, skip to
step 2 of the following section "Setting the
distance to the speakers".
To complete the settings, press SET UP.
z
If the sound is distorted
Select "SMALL" for the center speaker connection setting. Note
that "LARGE" should be normally selected to obtain satisfactory
surround effects.
Note
If you do not press CURSOR to start the setting operations within
approximately 8 seconds after pressing SET UP, the SET UP
button goes off.
Setting
NO
LARGE
SMALL
V
v
/
repeatedly until "WOOFER
*
[YES
]" appears in the display.
B
b
/
to select the sub woofer
connection status.
Sub woofer connection status
None
Connected
Setting
NO
YES
Advertisement
Table of Contents
