Surface Units - GE JBP2 Use And Care & Installation Manual

PROBLEM
SURFACE
FUNCTIONING
PROPERLY
OVEN WILL
NOT WORK
DOES NOT WORK
FOOD DOES
BROIL PROPERLY
ROAST OR BAKE
PROPERLY
OVEN DOOR
OVEN DOOR
ACCIDENTALLY LOCKED
OVEN DOOR WILL
NOT UNLOCK
OVEN NOT CLEAN
AFTER CLEAN CYCLE
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
Surface units are not plugged in solidly.
* Surface unit controls are not properly set.
The circuit breaker in your house has been tripped, or a fuse has been blown.
Oven controls not properly set.
Door left in locked position after cleaning.
. Light bulb is loose or defective. Tighten or replace.
The OVEN SET knob not set at BROIL.
Door not left open to the broil stop position as recommended.
Improper shelf position being used. See the Broiling Guide.
Food is being
cooked on hot pan.
Aluminum foil used on the broil pan rack has not been fitted properly and
slit as recommended.
The OVEN SET knob not set at BAKE.
Incorrect cookware or cookware of' improper size is being used.
Oven thermostat needs adjustment. See the Adjust the Oven Thermostat—
Because the oven door is removable, it sometimes gets out of position
during installation. To straighten the door, push down on the high corner.
Turn the OVEN TEMP knob to OFF". AI1ow oven to cool.
Never force the door latch handle.
Oven controls not set properly.
Heavy spillovers should be cleaned before starting clean cycle.
33