Epson PowerLite 1750 Installation Handbook
Hide thumbs
Also See for PowerLite 1750:
- User manual (193 pages) ,
- Quick setup manual (4 pages) ,
- Declaration of conformity (4 pages)
Advertisement
Quick Links
Epson PowerLite 1750 / 1760W / 1770W / 1775W
Replacing the Lamp
Before you replace the lamp, let the projector cool down for at least one hour so the lamp will not be hot.
Warning: Let the lamp fully cool before replacing it to avoid injury.
You can replace the lamp while the projector is mounted to the ceiling, if necessary.
1. Turn off the projector and unplug the power cord.
2. Allow the projector lamp to cool down for at least one hour.
3. Use the screwdriver included with the replacement lamp to loosen the screw securing the lamp
cover.
Warning: If the lamp is broken, glass fragments may be loose inside the lamp chamber. Be careful
removing any broken glass to avoid injury.
4. Slide the lamp cover out and lift it off.
INSTALLATION HANDBOOK
Lamp and Status Information
1
Advertisement
Related Manuals for Epson PowerLite 1750
Summary of Contents for Epson PowerLite 1750
- Page 1 INSTALLATION HANDBOOK Epson PowerLite 1750 / 1760W / 1770W / 1775W Lamp and Status Information Replacing the Lamp Before you replace the lamp, let the projector cool down for at least one hour so the lamp will not be hot.
- Page 2 INSTALLATION HANDBOOK Epson PowerLite 1750 / 1760W / 1770W / 1775W Lamp and Status Information 5. Lift up the metal bar securing the lamp. 6. Lift up the lamp handle and gently pull the lamp out of the projector. Caution: Lift the lamp handle carefully to avoid damaging the handle as you pull out the lamp.
- Page 3 INSTALLATION HANDBOOK Epson PowerLite 1750 / 1760W / 1770W / 1775W Lamp and Status Information 7. Gently insert the new lamp into the projector. If it does not fit easily, make sure it is facing the right way. Press down on the area shown to secure the lamp in place.
- Page 4 INSTALLATION HANDBOOK Epson PowerLite 1750 / 1760W / 1770W / 1775W Lamp and Status Information Resetting the Lamp Timer You must reset the lamp timer after replacing the projector's lamp to clear the lamp replacement message and to keep track of lamp usage correctly.