Start-Up; Attach Front Panel; Detach Front Panel; Replace The Remote Control Batteries - AEG AR 4021 BT Instruction Manual

Place the battery into the battery compartment with
‹
the positive pole at the top.
Close the battery compartment again.
‹
Plug the remote control onto the mounting bracket
‹
cover until it clicks into place.
Picture of the finished assembly, on the right hand side
of the steering wheel

Start-up

To protect against theft remove the front panel. Do not
keep the front panel in the car.
NOTE
►
Keep the front panel in its casing.
►
Do not touch the contacts on the unit or on the
front panel.

Attach Front Panel

Set the control panel with the left-hand side first into
‹
the frame.
Then push the right-hand side in until it clicks into
‹
place.
Flip the control panel up until it clicks into place.
‹
Ensure the front panel is attached properly. If the front
‹
panel is not attached properly this can cause malfunc-
tions.

Detach Front Panel

Press the release button (1) and flip the control panel
‹
down.
Then pull gently on the right-hand side of the control
‹
panel to detach the control panel.

Replace the remote control batteries

The battery of the remote control is a long life lithium cell.
If the range of the remote control becomes shorter whilst
in use, follow the steps below:
Open the battery compartment (17) of the remote
‹
control.
Replace the cell with a battery of the same type (CR
‹
2025). Make sure that the polarity is correct.
Close the battery compartment.
‹
If the remote control is not in use for long periods, please
remove the battery to prevent "leakage" of battery acid.
WARNING
Do not expose batteries to intense heat or direct sun-
light. Never throw batteries into a fire. Risk of explosi-
on!
CAUTION
Batteries should not be disposed of with household was-
te. Take spent batteries to designated collection points
or to a dealer.
ENGLISH
85