Advertisement
Step 3
Installation of Rear Duct
Note: It is easier to start all screws before
tightening any screw.
Remove one screw (D) on the back of the
microwave oven. Retain screw.
Install Rear Duct by inserting the bottom
flange between the oven and the back of
the Base Pan. The Rear Duct should be as
far to the right as possible. Drive two
screws (A) through the Base Pan and into
the Rear Duct bottom flange. Drive the
one screw (D) previously removed into
original holes on the side flanges. Drive
one screw (A) into the microwave oven.
Step 4
Installation of Top Duct
Slide the Top Duct (3) from the front
toward the Rear Duct. The partition
extending out from the Top Duct should
slide into the Rear Duct. Drive the two
Screws (A) through the Rear Duct into
the Top Duct. Drive one Screw (A)
through the side of the Rear Duct into the
partition extending from the Top Duct.
Step 5
Installation of the Microwave Oven
Plug the power cord into the wall recep-
tacle. Slide the microwave oven assembly
gently into the cabinet using care not to
pinch the power cord, and to keep it
centered as it slides back to where the
holddown bracket's tongue goes through
the rear slots. The unit should now be
centered right to left in the opening and
the Base Pan front flange tight against the
cabinet. Drive two screws (C) through the
Base Pan front flange into the holes
initially drilled. Bore two 3/32" dia. holes
in the cabinet using the top duct flange
holes to locate. Drive two (C) screws in
top duct flange.
Screw A
Screw A
Screw A
C L
Screw D
Screw D
Screws A
Screws A
Screws C
Screws C
V Notch
Screw C
Advertisement
