Electrical Connection; Data Plate - Miele H 2261 B Operating And Installation Instructions


CAUTION:
Before servicing, disconnect the
power supply by either removing the
fuse, shutting off the power main or
manually "tripping" the circuit
breaker.
Installation, repair and maintenance
work must be performed by a Miele
authorized service technician. Work
by unqualified persons could be
dangerous and may void the
warranty.
Before connecting the appliance to
the power supply, make sure that the
voltage and frequency listed on the
data plate correspond with the
household electrical supply. This
data must correspond to prevent
machine damage. Consult an
electrician if in doubt.
Only operate the appliance after it
has been installed into cabinetry.
The plug must be plugged into an
appropriate outlet that is installed
and grounded in accordance with all
local codes and ordinances.
WARNING: THIS APPLIANCE MUST
BE GROUNDED
Installer: Please leave these
instructions with the consumer.

Electrical connection

Data plate

The silver data plate is located along
the front side of the oven with the door
open (see "Guide to the oven").

Before connecting the appliance
to the power supply, make sure that
the voltage and frequency listed on
the data plate correspond with the
household electrical supply. This
data must correspond to prevent
machine damage. Consult an
electrician if in doubt.
Electrical connection 208 V

Do not connect the oven to a
240 V power supply.
The oven is equipped with a 6' 3"
(1.9 m) long flexible power cord with a
NEMA 14-30 P plug, ready for
connection to a 120/208 V, 60 Hz, 20 A
power supply.
Maximum connected load: 3,600 W
Electrical connection 240 V
The oven is equipped with a 6' 3"
(1.9 m) long flexible power cord with a
NEMA 14-30 P plug, ready for
connection to a 120/240 V, 60 Hz, 20 A
power supply.
Maximum connected load: 3,800 W
SAVE THESE INSTRUCTIONS FOR
THE ELECTRICAL INSPECTOR'S
USE.
NEMA 14-30P, L1, L2, N, G, 20 amp
208/240 VAC
73