Declaration Of Conformity - Bosch AHS 45-26 Original Instructions Manual

OBJ_BUCH-1549-004.book Page 13 Wednesday, September 10, 2014 7:12 AM
Hedgecutter
No-load stroke rate
Slipping Clutch Torque
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of your garden product. The trade names of the individual
garden products may vary.
Noise/Vibration Information
Sound emission values determined according to EN 60745-2-15.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to
h
EN 60745:
a
h
K
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main appli-
cations of the tool. However if the tool is used for different appli-
cations, with different accessories or insertion tools or is poorly
maintained, the vibration emission may differ. This may signifi-

Declaration of Conformity

We declare under our sole responsibility that the product described under "Technical data"
is in conformity with all relevant provisions of the directives 2011/65/EU, 2014/30/EU,
2006/42/EC, 2000/14/EC including their amendments and complies with the following
standards: EN 60745-1, EN 60745-2-15.
2000/14/EC: Guaranteed sound power level:
Conformity assessment procedure according to Annex V.
Equipment category: 25
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS23,
Stowmarket, Suffolk IP14 1EY, England
Bosch Power Tools
AHS 65-34 AHS 680-34
-1
min 3400 3400
Nm 50
kg 3.8
/II
cantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or when
it is running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the acces-
sories, keep the hands warm, organisation of work patterns.
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
29.08.2014
AHS 70-34
3400
50 50
3.9 3.9
/II /II
3 600 ...
dB(A)
dB(A)
dB
2
m/s
2
m/s
3 600 ...
dB(A)
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
F 016 L81 185 | (10.9.14)
English | 13
H47 E.. H47 J..
H47 F.. H47 K..
H47 G..
H47 H..
75 76
96 97
1 1
2.5 4.0
1.5 1.5
H47 E.. H47 J..
H47 F.. H47 K..
H47 G..
H47 H..
97 98