Brother MFC-L8600CDW Basic User's Manual page 118

Chapter B
Error Message
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray1
Jam Tray2
Limit Exceeded
Log Access Error
No Belt Unit
No Drum Unit
No HUB Support
No Paper
No Permission
No Response/Busy
No Toner
108
Cause
The paper is jammed inside the
machine.
The paper is jammed in the
multi-purpose tray of the
machine.
The paper is jammed in the
back of the machine.
The paper is jammed in the
paper tray of the machine.
The print limit set in Secure
Function Lock was reached.
The machine could not access
the print log file in the server.
The belt unit is not installed
correctly.
The drum unit is not installed
correctly.
A USB hub device is
connected to the USB direct
interface.
The machine is out of paper in
the paper tray, or paper is not
correctly loaded in the paper
tray.
Printing color documents is
restricted by Secure Function
Lock. The print job will be
canceled.
The number you dialed does
not answer or is busy.
The toner cartridge for the
color indicated on the
Touchscreen is not installed
correctly.
Action
See Paper is jammed inside the machine
on page 121.
See Paper is jammed in the multi-purpose tray
on page 117.
See Paper is jammed at the back of the
machine on page 119.
See Paper is jammed in the Paper Tray 1 or
Tray 2 on page 118.
Call your administrator to check your Secure
Function Lock Settings.
Call your administrator to check the Store Print
Log to Network settings.
For more information, see Software and
Network User's Guide.
Reinstall the belt unit, (see the steps in
Replacing the belt unit on page 90).
Reinstall the drum unit, (see the steps
in Replacing the drum unit on page 84.)
Disconnect the USB hub device from the USB
direct interface.
Do one of the following:
 Refill paper in the paper tray. Make sure the
paper guides are set to the correct size.
 Remove the paper and load it again. Make
sure the paper guides are set to the correct
size.
 If the problem is not resolved, the paper
pick-up roller may need to be cleaned.
Clean the paper pick-up roller.
(See Advanced User's Guide)
Call your administrator to check your Secure
Function Lock Settings.
Verify the number and try again.
Remove the drum unit, remove the toner
cartridge for the color indicated on the
Touchscreen from the drum unit, and reinstall
the toner cartridge back into the drum unit.
Reinstall the drum unit back in the machine. If
the problem continues, replace the toner
cartridge (see Replacing the toner cartridges
on page 75).